Subaru Outback (BR): Windshield wipers
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to the “OFF” position.
For a single wipe of the wipers, push the lever up. The wipers operate until
you release the lever.
READ NEXT:
When the wiper switch is in the “INT” position, turn the dial to adjust the operating
interval of the wiper. The operating interval can be adjusted in five steps from
the shortest interval t
To wash the windshield, pull the wiper control lever toward you. The washer fluid
sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fl
: Washer (accompanied by wiper operation)
ON: Continuous INT: Intermittent OFF: Off
: Washer (accompanied by wiper operation)
SEE MORE:
The audio set will operate only when the ignition switch is in the “Acc” or “ON”
position.
● Power and sound controls: refer to page 5-6
● Radio operation: refer to page 5-9
● Satellite radio operation (if equipped): refer to page 5-13
● CD (compact disc) play
A: REMOVAL
1) Disconnect the negative terminal from the battery, and wait for 60 seconds
or more.
2) Set the tire to the straight-ahead position.
3) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengag
© 2010-2024 Copyright www.suoutback.com