Subaru Outback (BR): Windshield wiper and washer switches
The wiper operates only when the ignition switch is in the “ON” position.
READ NEXT:
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to t
When the wiper switch is in the “INT” position, turn the dial to adjust the operating
interval of the wiper. The operating interval can be adjusted in five steps from
the shortest interval t
To wash the windshield, pull the wiper control lever toward you. The washer fluid
sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fl
SEE MORE:
1) Air intake duct 2) Air cleaner case 3) Clamp
1. Remove the hydraulic hose in the power steering system from the clip on the
air intake duct.
2. Remove the hydraulic hose from the clip on the right side of the air cleaner
case.
3. Unsnap the two clamps holding the air cleaner case cover.
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlights turn on automatically
However, the front fog lights turn off when the headlights are switched to
© 2010-2024 Copyright www.suoutback.com