Subaru Outback (BR): Front fog light switch (if equipped)
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlights turn on automatically
However, the front fog lights turn off when the headlights are switched to high
beam.
To turn on the front fog lights, turn the front fog light switch on the turn
signal lever upward to the “” position.
To turn off the front fog lights, turn the switch back down to the “OFF” position.
The indicator light located on the combination meter will illuminate when the
front fog lights are on.
READ NEXT:
WARNING
In freezing weather, do not use the windshield washer until the windshield is
sufficiently warmed by the defroster.
Otherwise the washer fluid can freeze on the windshield, blocking your v
The wiper operates only when the ignition switch is in the “ON” position.
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to t
SEE MORE:
A: REMOVAL
CAUTION:
When removing the front seat, Disconnect the ground cable from battery before
disconnecting the
side airbag module harness connector, and wait for 60 seconds before starting
the operation.
1. POWER SEAT SWITCH
1) Remove the seat from vehicle. <Ref. to SE-10, REMOVAL, Front S
A: REMOVAL
1. AUTO A/C MODEL
1) Disconnect the ground cable from battery.
2) Remove the center panel assembly.
CAUTION: Do not put your finger on the fin of the air vent grille. Doing so may damage the fin.
Attach the protective tape (a) to the meter visor.
Insert a finger int
© 2010-2024 Copyright www.suoutback.com