Subaru Outback (BR): Headlight flasher
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever toward you and then release it. The high
beam will stay on for as long as you hold the lever. The headlight flasher works
even though the lighting switch is in the “OFF” position.
When the headlights are on high beam, the high beam indicator light “”
on the combination meter also illuminates.
READ NEXT:
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“” position when it is dar
To activate the right turn signal, push the turn signal lever up. To activate
the left turn signal, push the turn signal lever down. When the turn is finished,
the lever will return automaticall
The illumination brightness of the clock display, audio, air conditioner, multi
function display and meter/gauge dims under the following conditions.
● when the light switch is in the “
SEE MORE:
A: DTC 11 DRIVER'S AIRBAG FAILURE
NOTE:
Be sure to properly identify the Airbag system type prior to performing any
diagnostics.
1. TYPE A
DTC DETECTING CONDITION:
Airbag main harness circuit is open, shorted or shorted to ground.
Airbag module harness (Driver's side) circuit is open, shorted or
A: SPECIFICATION
Non-turbo model
Recommended oil:
CAUTION: It is acceptable to fill an engine with oil of another brand when replacing the oil, but make sure to use the following engine oil specified by Subaru.
NOTE: The proper viscosity oil helps the engine maintain its ideal tempe
© 2010-2024 Copyright www.suoutback.com