Subaru Outback (BR): Sensor for the auto on/off headlights
The sensor is on the instrument panel as shown in the illustration.
CAUTION
If any object is placed on or near the sensor, the sensor may not detect the
level of the ambient light correctly and the auto on/off headlights may not operate
properly.
READ NEXT:
To change from low beam to high beam, push the turn signal lever forward. When
the headlights are on high beam, the high beam indicator light “”
on the combination meter is also on.
To swit
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever toward you and then release it. The high
beam will stay on for as
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“” position when it is dar
SEE MORE:
1) Rear window defogger
2) Outside mirror defogger (if equipped)
3) Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear window defogger. Some models are also equipped
with an outside mirror defogger and/or windshield wiper deicer. The defogger and
deicer system is acti
The synthetic leather material used on the SUBARU may be cleaned using mild soap
or detergent and water, after first vacuuming or brushing away loose dirt. Allow
the soap to soak in for a few minutes and wipe off with a clean, damp cloth. Commercial
foam-type cleaners suitable for synthetic le
© 2010-2024 Copyright www.suoutback.com