Subaru Outback (BR): Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display.
The display can be switched as shown in the following illustration by pressing
the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
NOTE
● The initial setting for your vehicle of the gear position indicator has been
set for activation “” at the time of
shipment from the factory.
● It is not possible to change the setting of the gear position indicator when
the ignition switch is in the “ON” position. Change the setting when the ignition
switch is in the “LOCK” or “Acc” position.
READ NEXT:
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may
be burned out. Replace the bulb as soon a
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
SEE MORE:
WARNING
● Never tow a trailer when the temporary spare tire is used. The temporary spare
tire is not designed to sustain the towing load. Use of the temporary spare tire
when towing can result in failure of the spare tire and/or less stability of the
vehicle and may lead to an accident.
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door Trim.>
3) Remove the outer mirror assembly. <Ref. to GW-28, REMOVAL, Outer Mirror
Assembly.>
4) Remove the front door speaker assembly.
Remove the screws
© 2010-2024 Copyright www.suoutback.com