Subaru Outback (BR): Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may indicate that immobilizer system may be malfunctioning. Contact your nearest SUBARU dealer immediately. In the event that an unauthorized key (for example, an unauthorized duplicate) is used, the security indicator light illuminates.
READ NEXT:
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever
(AT and CVT models).
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuousl
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “
SEE MORE:
Precaution
A: CAUTION
Please clearly understand and adhere to the following
general precautions. They must be strictly followed
to avoid minor or serious injury to the person
doing the work or people in the area.
1. VEHICLE DYNAMICS CONTROL (VDC)
Handle the VDC as a total system. Do not disassemble
A: REMOVAL
NOTE:
Refer to "Drive Pinion Shaft" for removal procedures. <Ref. to CVT-242, REMOVAL,
Drive Pinion Shaft Assembly.>
B: INSTALLATION
NOTE:
Refer to "Drive Pinion Shaft" for removal procedures. <Ref. to CVT-244,
INSTALLATION, Drive Pinion Shaft
Assembly.>
C: INSPECTION
Check
© 2010-2024 Copyright www.suoutback.com