Subaru Outback (BR): Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short period of time after the engine
has been started, especially in cold weather. This does not indicate the existence
of a problem. The light should turn off as soon as the engine has warmed up.
● The indicator light illuminates when the engine has developed a problem and the
CHECK ENGINE warning light/ malfunction indicator lamp is on. The Vehicle Dynamics
Control system is probably malfunctioning under the following condition. Have your
vehicle checked at a SUBARU dealer as soon as possible.
● The light does not turn off even after the lapse of several minutes (the engine
has warmed up) after the engine has started.
READ NEXT:
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch
SEE MORE:
A: INSPECTION
Check the rear differential mount bushing for
cracks, hardening or damage. If cracking, hardening
or damage is excessive, replace rear differential
mount bushing.
B: REPLACEMENT
CAUTION:
If there was so much rust in the rear differential
mount bushing, remove the rust before
starti
A: REMOVAL
1. INTAKE MANIFOLD
1) Release the fuel pressure.
2) Disconnect the ground cable from battery.
3) Open the fuel filler lid and remove the fuel filler
cap.
4) Remove the cover (A) and clip (B) from air intake
boot assembly.
5) Loosen the clamp (A) which connects the air intake
boot asse
© 2010-2024 Copyright www.suoutback.com