Subaru Outback manuals

Subaru Outback (BR): All-Wheel Drive warning light (AT and CVT models)

WARNING


WARNING

Continued driving with the AWD warning light flashing can lead to powertrain damage. If the AWD warning light flashes, promptly park in a safe place then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason.

The All-Wheel Drive warning light illuminates when the ignition switch is turned to the “ON” position and turns off after the engine has started.

READ NEXT:

 For AT models

This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires.

 For CVT models

This light illuminates when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes. This light flashes if the vehicle is driven

 VDC warning light / VDC operation indicator light

The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle

SEE MORE:

 Windshield wiper blade rubber

1) Support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines 2. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and install them

 Knock Sensor

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the cover (A) and clip (B) from air intake boot assembly. 3) Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case. 4) Loosen the clamp (B) which connects the air intake boot assembly and throttle bo

© 2010-2024 Copyright www.suoutback.com