Subaru Outback (BR): Canceling the function for meter/gauge needle movement upon turning on the ignition
switch
It is possible to activate or deactivate the movement of the meter needles and
gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display
The display can be switched as shown in the following illustration by pressing
the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
● Your vehicle’s initial movement setting of the meter/gauge needles has been
set for activation “ ” at the time of shipment from the factory.
● It is not possible to change the initial movement setting of the meter/gauge needles
when the ignition switch is in the “ON” position. Change the setting when the ignition
switch is in the “LOCK” or “Acc” position.
READ NEXT:
The speedometer shows the vehicle speed.
This meter displays the odometer when the ignition switch is in the “ON” position.
The odometer shows the total distance that the vehicle has been driven.
If you press the trip knob when the
1) Trip knob
This meter displays the two trip meters when the ignition switch is in the “ON”
position.
The trip meter shows the distance that the vehicle has been driven since you
last set
SEE MORE:
SRS airbag system warning light
A diagnostic system continually monitors the readiness of the seatbelt pretensioner
while the vehicle is being driven. The seatbelt pretensioners share the control
module with the airbag system. Therefore, if any malfunction occurs in a seatbelt
pretensioner,
When the ignition switch is in the “ON” position, the door open warning light
illuminates for approximately 2 seconds and then turns off.
The door open warning light illuminates if any door, the rear gate (Outback)
or trunk lid (Legacy) is not fully closed. This function is effective even
© 2010-2024 Copyright www.suoutback.com