Subaru Outback (BR): Meters and gauges
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Meters and gauges
NOTE
Liquid crystal displays are used in some of the meters and gauges in the combination meter. You will find their indications hard to see if you wear polarized glasses.
- Combination meter illumination
- Canceling the function for meter/gauge needle movement upon turning on the ignition switch
- Speedometer
- Odometer
- Double trip meter
- Tachometer
- Fuel gauge
- ECO gauge
READ NEXT:
Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of
the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles
Canceling the function for meter/gauge needle movement upon turning on the ignition
switch
It is possible to activate or deactivate the movement of the meter needles and
gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition swi
Speedometer
The speedometer shows the vehicle speed.
SEE MORE:
Drive Cycle
A: PROCEDURE
It is necessary to perform the drive cycle listed below if DTC is not found
in the Inspection Mode. It is possible
to complete diagnosis of the DTC by performing the indicated drive cycle. After
the repair for the DTC, perform
a necessary drive cycle and make sure the function recover
MT Gear Select Cable
A: REMOVAL
CAUTION:
Always use new MT gear select cable if the cable is removed from selector lever
COMPL of transmission
side.
1) Disconnect the ground cable from battery.
2) Remove the ten clips and remove the grille bracket.
3) Remove the air intake duct.
Non-turbo model
<Ref. to IN(H4S
© 2010-2024 Copyright www.suoutback.com
