Subaru Outback (BR): Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered.
Also, the number of flashes indicates the location of unauthorized intrusion or
the severity of impact on the vehicle.
When the ignition switch is turned to the “ON” position, the indicator light
will illuminate for 1 second and then flash as follows:
● When a door or rear gate (Outback) was opened: 5 times
● When the trunk (Legacy) was opened: 4 times
● When a strong impact or multiple impacts were sensed: twice (only models with
shock sensors (dealer option))
● When a light impact was sensed: once (only models with shock sensors (dealer option))
READ NEXT:
The shock sensors trigger the alarm system when they sense impacts applied to
the vehicle and when any of their electric wires is cut. The alarm system causes
the horn to sound and the turn signal
WARNING
Always turn the child safety locks to the “LOCK” position when children sit on
the rear seat. Serious injury could result if a child accidentally opens the door
and falls out.
Each
WARNING
To avoid serious personal injury caused by entrapment, always conform to the
following instructions without exception.
● When operating the power windows, be extremely careful to pre
SEE MORE:
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
1) Power steering fluid reservoir (page 11-27)
2) Manual transmission oil level gauge (page 11-23)
3) Clutch fluid reservoir (page 11-29)
4) Brake fluid reservoir (page 11-28)
5) Fuse box (page 11-46)
6) Battery (page 11-45)
7) Windshield washer tank (page 11-40)
8) Engine oil filler cap (p
© 2010-2024 Copyright www.suoutback.com