Subaru Outback (BR): Arming the system
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT
automatically lock the doors. In order to lock the doors you must either lock them
as indicated in step 4 below or with the key once they have been closed. Failure
to lock the doors manually will result in a higher security risk.
1. Turn the ignition switch to the “ON” position.
1) LOCK
2) ON
2. Turn the ignition switch from “ON” to “LOCK” position and remove the key from
the ignition switch.
3. Open the doors and get out of the vehicle.
4. Before closing the doors, lock all doors with the inside door lock levers.
5. Close the doors. The system will automatically arm after 1 minute.
In the passive mode, the system can also be armed with the remote transmitter
or with the power door locking switches. If the remote transmitter or power door
locking switch is used to lock the vehicle, arming will take place immediately regardless
of whether or not the passive mode has been selected.
Disarming the system
To disarm the system, briefly press the “”
button on the transmitter.
READ NEXT:
The security indicator light flashes when the alarm system has been triggered.
Also, the number of flashes indicates the location of unauthorized intrusion or
the severity of impact on the vehicle
The shock sensors trigger the alarm system when they sense impacts applied to
the vehicle and when any of their electric wires is cut. The alarm system causes
the horn to sound and the turn signal
WARNING
Always turn the child safety locks to the “LOCK” position when children sit on
the rear seat. Serious injury could result if a child accidentally opens the door
and falls out.
Each
SEE MORE:
The front passenger’s frontal airbag ON and OFF indicators show you the status
of the front passenger’s SRS frontal airbag. The indicators are located next to
the clock in the center portion of the dashboard.
When the ignition switch is turned to the “ON” position, both the ON and O
A: REMOVAL
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of
secondary speed sensor. If
adhesion occurs, replace with a new part.
1) Remove the transmission from the vehicle. <Ref. to CVT-55, REMOVAL,
Automatic Transmission Assembly.>
2) Remove the transmiss
© 2010-2024 Copyright www.suoutback.com