Subaru Outback (BR): Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for
deactivation mode. Refer to “Activating and deactivating the alarm system” F2- 16.
The security indicator light will continue to flash once every 3 seconds indicating
that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle’s alarm system for activation
mode. Refer to “Activating and deactivating the alarm system” F2-16.
READ NEXT:
When passive arming mode has been programmed by the dealer, arming of the system
is automatically accomplished without using the remote transmitter. Note that in
this mode, DOORS MUST BE MANUALLY
If you wish to program the passive arming mode, have it done by your SUBARU dealer.
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT
automatically lock the doors. In order to lock the doors you must either lock them
as indicated in step 4 be
SEE MORE:
CAUTION
● Do not let dust, oil or water get on or in the transmitter when replacing the
battery.
● Be careful not to damage the printed circuit board in the transmitter when replacing
the battery.
● Be careful not to allow children to touch the battery and any removed parts;
A: DTC P0026 INTAKE VALVE CONTROL SOLENOID CIRCUIT RANGE/PERFORMANCE
(BANK 1)
DTC DETECTING CONDITION:
Immediately at fault recognition
GENERAL DESCRIPTION <Ref. to GD(H4SO)-9, DTC P0026 INTAKE VALVE CONTROL
SOLENOID
CIRCUIT RANGE/PERFORMANCE (BANK 1), Diagnostic Trouble Code (DTC) Detectin
© 2010-2024 Copyright www.suoutback.com