Subaru Outback (BR): To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid (Legacy)) are locked.
5. Close all doors (and the rear gate (Outback)).
6. Briefly press the “” button (for
less than 2 seconds). All doors (and the rear gate (Outback)) will lock, an electronic
chirp will sound once, the turn signal lights will flash once, and the security
indicator light will start flashing rapidly. After rapid flashing for 30 seconds
(standby time), the security indicator light will then flash slowly (twice approximately
every 2 seconds), indicating that the system has been armed for surveillance.
If any of the doors (rear gate or trunk lid) is not fully closed, an electronic
chirp sounds five times, the turn signal lights flash five times to alert you that
the doors (or the rear gate) are not properly closed. When you close the door, the
system will automatically arm and doors will automatically lock.
READ NEXT:
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice
If you cannot disarm the system using the transmitter (i.e. the transmitter is
lost, broken or the transmitter battery is too weak), you can disarm the system
without using the transmitter.
The s
SEE MORE:
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the engine oil level decreases to the lower
limit. The illuminating conditions and remaining oil level a
Basic Diagnostic Procedure
A: PROCEDURE
Check List for Interview
A: CHECK
General Description
A: CAUTION
1) If the seat cushion cover is removed or replaced,
make sure to perform the occupant detection system
adjustment after installing the seat to the vehicle.
<Ref. to OD(diag)-15, System Cal
© 2010-2024 Copyright www.suoutback.com