Subaru Outback (BR): Alarm system
The alarm system helps to protect your vehicle and valuables from theft. The
horn sounds and the turn signal lights flash if someone attempts to break into your
vehicle.
The system can be armed and disarmed with the remote transmitter.
The system does not operate when the key is inserted into the ignition switch.
Your vehicle’s alarm system has been set for activation at the time of shipment
from the factory. You can set the system for deactivation yourself or have it done
by your SUBARU dealer.
READ NEXT:
The alarm system will give the following alarms when triggered:
● The vehicle’s horn will sound and the turn signal lights will flash for 30
seconds.
● If any door (or the rear gate/
To change the setting of your vehicle’s alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to “Disarming the system” F2-18.
2. Sit in the driver
To stop the alarm
Perform any of the following operations.
● Press any button on the remote transmitter.
● Turn the ignition switch to the “ON” position.
SEE MORE:
WARNING
● Never turn the ignition switch to “LOCK” while the vehicle is being driven
or towed because that will lock the steering wheel, preventing steering control.
And when the engine is turned off, it takes a much greater effort than usual to
steer.
● Before leaving the ve
A: REMOVAL
1) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) while
moving them forward.
2) Remove the battery.
3) Lift up the vehicle.
4) Remove the under cover. <R
© 2010-2024 Copyright www.suoutback.com