Subaru Outback manuals

Subaru Outback: Replacing the battery

CAUTION

● Do not let dust, oil or water get on or in the transmitter when replacing the battery.

● Be careful not to damage the printed circuit board in the transmitter when replacing the battery.

● Be careful not to allow children to touch the battery and any removed parts; children could swallow them.

● There is a danger of explosion if an incorrect replacement battery is used. Replace only with the same or equivalent type of battery.

● Batteries should not be exposed to excessive heat such as sunshine, fire or the like.

If the transmitter fails to operate when used within the standard distance, this may indicate a weak battery. Replace the battery as soon as possible. The battery can be replaced by your authorized SUBARU dealer. If you replace the battery by yourself, use utmost care that no dust, oil or water enters the transmitter.

To replace the battery:

1. Remove the screw on the key head.


1. Remove the screw on the key head.

2. Open the key head using a flat-head screwdriver.


2. Open the key head using a flat-head screwdriver.

3. Remove the transmitter case from the key head.


3. Remove the transmitter case from the key head.

4. Open the transmitter case by releasing the hooks.


4. Open the transmitter case by releasing the hooks.

1) Negative (−) side facing up


1) Negative (−) side facing up

5. Replace the old battery with a new battery (Type CR1620 or equivalent) making sure to install the new battery with the negative (−) side facing up.

6. Put together the transmitter case by fitting the hooks on the case.

7. Reinstall the transmitter case in the key head.

8. Reinstall the screw on the key head.

After the battery is replaced, the transmitter must be synchronized with the remote keyless entry system’s control unit. Press either the “or “” button six times to synchronize
or “the unit.” button six times to synchronize
the unit.

READ NEXT:

 Replacing lost transmitters

If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should reprogram all of your transmitters for security reasons. It is recommended that you

 Programming the transmitters

The remote keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to

 Deleting old transmitter codes

The control unit of the remote keyless entry system has four memory locations to store transmitter codes, giving it the ability to operate with up to four transmitters. When you lose a transmitter

SEE MORE:

 Intake (Induction)

General Description A: COMPONENT Air intake duct Clip Resonator chamber Air cleaner case (front) Spacer Cushion Air cleaner element Air cleaner case (rear) Clip Clamp Cover Clip Air intake boot ASSY Clamp Cushion Mass air flow and intake air temperature sensor Blow-by hose Clip

 General Description

A: SPECIFICATION *1: OUTBACK model 2+-3 mm (0.08 - 0.12 in) Toe angle (sum of both wheels): 0º10′+-0º15′ *2: Except for OUTBACK model 0+-3 mm (0+-0.12 in) Toe angle (sum of both wheels): 0º+-0º15′ NOTE: Front and rear toe-in and front camber can be adjusted. Adjust if the

© 2010-2024 Copyright www.suoutback.com