Subaru Outback (BR): Security indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Immobilizer / Security indicator light
The security indicator light deters potential thieves by indicating that the vehicle is equipped with an immobilizer system. It begins flashing approximately 60 seconds after the ignition switch is turned from the “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out.
If the security indicator light does not flash, the immobilizer system may be malfunctioning. If this occurs, contact your SUBARU dealer as soon as possible. In case an unauthorized key is used (e.g. an imitation key), the security indicator light illuminates.
NOTE
Even if the security indicator light flashes irregularly or its fuse blows (the light does not flash if its fuse is blown), the immobilizer system will function normally.
READ NEXT:
Key replacement
Your key number plate and security ID plate will be required if you ever need
a replacement key made. Any new key must be registered for use with your vehicle’s
immobilizer system before it can
Locking and unlocking from the outside
To lock the driver’s door from the outside with the key, turn the key toward
the rear. To unlock the door, turn the key toward the front.
Pull the outside door handle to open an unlocked door.
SEE MORE:
Wiper and washer
WARNING
In freezing weather, do not use the windshield washer until the windshield is
sufficiently warmed by the defroster.
Otherwise the washer fluid can freeze on the windshield, blocking your view.
CAUTION
● Do not operate the washer continuously for more than 10 seconds, or when the
Fuel (tank, pump, sensors)
A: PROCEDURE
1. RELEASING OF FUEL PRESSURE
WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION: Be careful not to spill fuel.
1) Remove the fuse of fuel pump from main fuse box.
2) Start the engine and run it until it stalls.
3) After the engine stalls, crank it fo
© 2010-2024 Copyright www.suoutback.com
