Subaru Outback (BR): Tether anchorage location
Outback
Three tether anchorages, i.e., ones for the right, center and left positions,
are already installed on the rear edge of the roof. Open the cover flap to use each
anchorage.
READ NEXT:
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Outback
1. Remove the
*SRS: This stands for supplemental restraint system. This name is used because
the airbag system supplements the vehicle’s seatbelts.
Your vehicle is equipped with a crash sensing and diagnostic
Your vehicle is equipped with a supplemental restraint system in addition to
a lap/shoulder belt at each front seating position and each rear window-side seating
position. The supplemental restrai
SEE MORE:
A: REMOVAL
1. SEDAN MODEL
CAUTION:
Refer to "CAUTION" of "General Description" before handling the airbag module.
<Ref. to AB-9,
CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting wo
Basic Diagnostic Procedure
A: PROCEDURE
CAUTION:
Before removal or installation, be sure to remove any foreign matter (dust,
moisture, oil, etc.) from
the TPMS & keyless entry control module connector.
NOTE:
To check harness for open or short circuits, shake the suspected trouble spot or
conne
© 2010-2024 Copyright www.suoutback.com