Back-up light (5-door)

1. Apply a flat-head screwdriver to the light cover as shown in the illustration, and pry the light cover off from the rear gate trim.

1. Apply a flat-head screwdriver to the light cover as shown in the illustration, and pry the light cover off from the rear gate trim.

2. Turn the bulb socket counterclockwise and remove it.

2. Turn the bulb socket counterclockwise and remove it.

3. Pull the bulb out of the bulb socket and replace it with a new one.

3. Pull the bulb out of the bulb socket and replace it with a new one.

4. Install the bulb socket by turning it clockwise.

5. Install the light cover on the rear gate.

    See also:

    ON
    This is the normal operating position after the engine is started. ...

    Towing and tie-down hooks/holes
    The towing hooks should be used only in an emergency (e.g., to free a stuck vehicle from mud, sand or snow). CAUTION ● Use only the specified towing hooks and tie-down hooks/holes. Never use ...

    Front passenger’s cup holder
    The dual cup holder is built into the center console. ...