5-door models
1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly.
2. Slide the rear combination light assembly rearward and remove it from the vehicle.
1) Rear side marker light
2) Rear turn signal light
3. Remove the bulb socket from the rear combination light assembly by turning it counterclockwise.
4. Pull the bulb out of the bulb socket and replace it with a new one.
5. Set the bulb socket into the rear combination light assembly and turn it clockwise until it locks.
6. Put the rear combination light assembly into place while aligning the clip with the guide on the vehicle.
7. Tighten the upper and lower screws.
See also:
New electronic parking brake and hill-hold function
The all-disc braking system, with ABS and EBD (Electronic Brake-force
Distribution) as standard, has a linear feel with retardation corresponding
closely to applied brake pedal pressure. A redesig ...
Selection of manual mode
With the vehicle either moving or stationary,
move the select lever from the “D”
position to the manual gate then move it to
the “+” end or “−” end of the manual gate
to select manua ...
California Perchlorate Advisory
Certain vehicle components such as airbag modules, seatbelt pretensioners and
keyless entry transmitter batteries may contain perchlorate material. Special handling
may apply for service or vehicl ...