Subaru Outback (BR): Rear seatbelts (except rear center seatbelt on Outback)
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted.
If the belt stops before reaching the buckle, return the belt slightly and pull
it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly
after giving a strong pull on it, then pull it out slowly again.
3. Insert the tongue plate into the buckle until you hear a click.
4. To make the lap part tight, pull up on the shoulder belt.
5. Place the lap belt as low as possible on your hips, not on your waist.
READ NEXT:
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door.
1) Center seatbelt tongue plate
2) Connector (tongue)
3) Connector (buckle)
4) Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing twisted can increase the risk or severity
Push the release button of the center seatbelt buckle (on the left-hand side)
to unfasten the seatbelt.
1. Insert a key or other hard pointed object into the slot in the connector (buckle)
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the axle nut.
CAUTION: Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub bearing.
Lift the crimped section of axle nut.
Remove the axle nut using a socket wrench while de
CAUTION
If the CHECK ENGINE warning light/ malfunction indicator lamp illuminates while
you are driving, have your vehicle checked/repaired by your SUBARU dealer as soon
as possible. Continued vehicle operation without having the emission control system
checked and repaired as necessary could
© 2010-2024 Copyright www.suoutback.com