Subaru Outback (BR): Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited
for the driver/front passenger. Always adjust the anchor height so that the shoulder
belt passes over the middle of the shoulder without touching the neck.
To raise:
Slide the anchor up.
To lower:
Push the release button and slide the anchor down.
Pull down the anchor to make sure that it is locked in place.
WARNING
When wearing the seatbelts, make sure the shoulder portion of the webbing does
not pass over your neck. If it does, adjust the seatbelt anchor to a lower position.
Placing the shoulder belt over the neck may result in neck injury during sudden
braking or in a collision.
READ NEXT:
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door.
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted.
If the belt stops before reaching the buckle, return the belt slightly and pull
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door.
SEE MORE:
Making a phone call from the phone book
It is possible to select a phone number from the phonebook registered with the
invehicle equipment to make a phone call.
1. Press the OFF hook switch . Preset buttons
2. Press the preset button in which the desired number is registered.
3. Press the OFF
CAUTION
Prevent brake fluid from coming into contact with your eyes, as it can cause harm. In case of eye contact, immediately rinse them thoroughly with clean water. It's recommended to wear eye protection when working with brake fluid for safety reasons.
Brake fluid has the ability to absorb moi
© 2010-2024 Copyright www.suoutback.com