Subaru Outback manuals

Subaru Outback (BR): Front seatbelts

1. Adjust the seat position:

Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control. Front passenger’s seat: Adjust the seatback to the upright position. Move the seat as far back as possible.

2. Sit well back in the seat.

3. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving it a strong pull, then pull it out slowly again.

4. Insert the tongue plate into the buckle until you hear a click.


4. Insert the tongue plate into the buckle until you hear a click.

5. To make the lap part tight, pull up on the shoulder belt.


5. To make the lap part tight, pull up on the shoulder belt.

6. Place the lap belt as low as possible on your hips, not on your waist.

READ NEXT:

 Adjusting the front seat shoulder belt anchor height

The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle of

 Unfastening the front seatbelt

Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door.

 Rear seatbelts (except rear center seatbelt on Outback)

1. Sit well back in the seat. 2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull

SEE MORE:

 Front Inner Remote

A: REMOVAL 1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.> 2) Remove the screws to detach the front inner remote handle. B: INSTALLATION 1) Before installation, check the following items. Cable is free from deformation such as fray. Grease is applied sufficiently to cable jo

 Generator

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the V-belts. <Ref. to ME(H4SO)-43, VBELT, REMOVAL, V-belt.> <Ref. to ME(H4DOTC)-42, V-BELT, REMOVAL, V-belt.> <Ref. to ME(H6DO)-51, REMOVAL, V-belt.> 3) Disconnect the connector and terminal from generator. 4) Re

© 2010-2024 Copyright www.suoutback.com