Hill start assist system (MT models – if equipped)
Ensure that the Hill start assist system operates properly under the following circumstances:
1. Stop the vehicle on an uphill grade by depressing the brake pedal and clutch pedal, with the engine running.
2. Make sure that the vehicle does not move backward even after the brake pedal is released.
3. Then make sure the vehicle starts climbing the grade by following the normal starting procedures.
If the Hill start assist system does not operate as described above, contact with your SUBARU dealer.
See also:
For AT models
This light flashes if the vehicle is driven with tires of different diameters
fitted on its wheels or with the air pressure excessively low in any of its tires. ...
Rear passenger cup holder (if equipped)
Rear passenger cup holder (if equipped)
A dual cup holder is located on the rear
seat center table. ...
Trunk light
1. Remove the cover by squeezing its sides and pulling it.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the cover. ...