Turbo models

1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct.

1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct.

1) Connector

1) Connector
2) Clip

2. Unplug the connector that is attached to the top of the air cleaner case.

3. Unsnap the two clips holding the air cleaner case cover.

4. Open the air cleaner case and remove the air cleaner element.

4. Open the air cleaner case and remove the air cleaner element.

5. Clean the inside of the air cleaner case and case cover with a damp cloth and install a new air cleaner element.

6. If the air cleaner case has been removed, insert the three projections on the air cleaner case into the slits on the air cleaner case cover.

6. If the air cleaner case has been removed, insert the three projections on the air cleaner case into the slits on the air cleaner case cover.

7. Install in the reverse order of removal.

    See also:

    Registering speed dial
    1. After registering phonebook data, select the “SPEED DIAL” menu. 2. Press the preset button (from to ) in which you want to register the phone number. NOTE If the number to be used is al ...

    Front fog light (if equipped)
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Pull off the fender lining. Refer to “Pulling off the fender lin ...

    To arm the system using power door locking switches
    1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors and the rear g ...