Precautions for AWD models with automatic transmission

Your vehicle is equipped with the AWD (All-Wheel Drive) system. In addition, if your vehicle is an AT model, before driving your vehicle with the temporary spare tire, deactivate the AWD capability of the vehicle as follows.

1. Turn the ignition switch to the “LOCK” position.

2. Pull any one spare fuse out of the spare fuse holder in the engine compartment.

2. Pull any one spare fuse out of the spare fuse holder in the engine compartment.

Spare fuses are attached on the back side of the fuse holder cover. You may pick up any one fuse in the spare fuse holder.

1) Spare fuse

1) Spare fuse
2) FWD connector

3. Put a spare fuse inside the FWD connector located in the cabin and confirm that the All-Wheel Drive warning light “AWD” illuminates. The All-Wheel-Drive capability of the vehicle has now been deactivated.

NOTE
After reinstalling the conventional tire, remove the spare fuse from the FWD connector in order to reactivate All- Wheel Drive. Make sure to restore the removed spare fuse in the spare fuse holder located in the engine compartment.

    See also:

    Trailer safety chains
    WARNING Always use safety chains between your vehicle and the trailer. Towing trailer without safety chains could create a traffic safety hazard if the trailer separates from the hitch due to cou ...

    Other markings
    The following makings are also placed on the sidewall. ...

    EXTERIOR
    The 2011 STi oozes speed. My test vehicle was the new four-door wide-body sedan with an intimidating-looking rear spoiler intended to amplify the car's aerodynamics. The spoiler definitely took a ...