Installing carrying attachments on the crossbars
When installing any carrying attachment such as a bike carrier, ski carrier, kayak carrier, cargo basket, etc. on the crossbars, follow the manufacturer’s instructions and make sure that the attachment is securely fixed to the crossbars. Use only attachments designed specifically for the crossbars. A set of the crossbars is designed to carry loads (cargo and attachment) of not more than 165 lbs (75 kg).
Before operating the vehicle, make sure that the cargo is properly secured on the attachment.
NOTE
Remember that the vehicle’s center of gravity is altered with the weight of the load on the roof, thus affecting the driving characteristics.
Drive carefully. Avoid rapid starts, hard cornering and abrupt stops. Crosswind effects will be increased.
See also:
Seat fabric
Remove loose dirt, dust or debris with a vacuum cleaner. If the dirt is caked on the fabric or hard to remove with a vacuum cleaner, use a soft brush then vacuum it.
Wipe the fabric surface with a ti ...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with the warning message
indicated by sending a signal from a sensor that is installed in each wheel when
tire pressure is severely low.
...
Anchorage location
1) For right seat
2) For center seat
3) For left seat
There is an anchorage located on the rear
edge of the ceiling above each seating
position. ...