Subaru Outback (BR): Seat heater (if equipped)
1) HIGH – Rapid heating
2) LOW – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side
The seat heater operates when the ignition switch is either in the “Acc” or “ON” position.
To turn on the seat heater, press the “LOW” or “HIGH” position on the switch, as desired, depending on the temperature. Selecting the “HIGH” position will cause the seat to heat up quicker.
To turn off the seat heater, slightly press the opposite side of the current position. The indicator located on the switch illuminates when the seat heater is in operation. When the vehicle’s interior is warmed enough or before you leave the vehicle, be sure to turn the switch off.
CAUTION
● There is a possibility that people with delicate skin may suffer slight burns even at low temperatures if they use the seat heater for a long period of time. When using the heater, always be sure to warn the persons concerned.
● Do not put anything on the seat which insulates against heat, such as a blanket, cushion, or similar items. This may cause the seat heater to overheat.
NOTE
Use of the seat heater for a long period of time while the engine is not running can cause battery discharge.
READ NEXT:
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits well back and upright
in the seat. Do not put cushions or any other materials between occupants and seatbacks
or seat cushions
Reclining the seatback (Outback)
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
CAUTION
If the vehi
Folding down the rear seatback
WARNING
● When you fold down the seatback, check that there are no passengers or objects on the rear seat. Not doing so creates a risk of injury or property damage if the seatback suddenly folds
SEE MORE:
Seatbelt warning light and chime
NOTE
If your seatbelt warning device does not operate as described in the following,
it may be out of order. Have the device inspected and, if necessary, repaired by
the nearest SUBARU dealer.
Your vehicle is equipped with a seatbelt warning device at the driver’s and front
passenger’s s
Power Seat System
A: REMOVAL
CAUTION:
When removing the front seat, Disconnect the ground cable from battery before
disconnecting the
side airbag module harness connector, and wait for 60 seconds before starting
the operation.
1. POWER SEAT SWITCH
1) Remove the seat from vehicle. <Ref. to SE-10, REMOVAL, Front S
