Auto mode
In the auto mode, the system estimates the driving and road conditions using signals from the wheel speed sensor, throttle position sensor, steering angle sensor and brake switch, etc. According to the result, it electronically and automatically controls the degree of limitation of the differential action (LSD torque) to optimize the differential action of the center differential. When the ignition switch is turned ON, the “AUTO” indicator light on the combination meter illuminates.
The auto mode has 3 modes as follows.
Mode setting method
In most situations, it is recommended that the “AUTO” mode is selected.
Push the control switch forward to select the “AUTO [+]” mode. After setting the mode, “” on the combination meter illuminates.
Pull the control switch rearward to select the “AUTO [−]” mode. After setting the mode, “” on the combination meter illuminates.
When the “AUTO [+]” mode is selected, pull the control switch rearward to change to the “AUTO” mode. When the “AUTO [−]” mode is set, push the control switch forward to change to the “AUTO” mode.
See also:
Seatbelt maintenance
To clean the seatbelts, use a mild soap
and lukewarm water. Never bleach or dye
the belts because this could seriously
affect their strength.
Inspect the seatbelts and attachments
including t ...
Side mirrors
Side mirrors
After hitching a trailer to your vehicle,
check that the standard side mirrors
provide a good rearward field of view
without significant blind spots. If significant
blind spo ...
Turbo models
1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct.
1) Connector
2) Clip
2. Unplug the connector that is attached to the top of the air cleaner case. ...