Displaying satellite radio ID of tuner

When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.

The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support.

The satellite radio ID can be found on the audio display by tuning the channel to “0”.

Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.

NOTE
For Sirius, change the display to an indication mode other than the channel number after performing the above operation.

    See also:

    California proposition 65 warning
    WARNING Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive ...

    Satellite radio operation (if equipped)
    To receive satellite radio, it is necessary to install the SUBARU genuine satellite receiver for some models, and to enter into a contract with a satellite radio network service such as “XMTM sate ...

    Operating the driver’s window (type A)
    Operating the driver’s window (type A) 1) Automatically open/close 2) Open/close To open: Press the switch down lightly and hold it. The window will open as long as the switch is held. This ...