Airflow control dial
Airflow control dial
Each dial position activates the following air outlets.
AUTO: The airflow control is adjusted automatically in accordance with the air temperature inside and outside the passenger compartment, the intensity of sunlight, and other factors. SUBARU recommends using the AUTO position.
(Ventilation): Instrument panel
outlets
(Bi-level): Instrument panel
outlets and foot outlets
(Heat): Foot outlets, both side
outlets of the instrument panel and some through windshield defroster outlets (A small amount of air flows to the windshield and both side windows to prevent fogging.)
(Heat-def): Windshield defroster
outlets, foot outlets and both side outlets of the instrument panel
: Windshield defroster outlets and
both side outlets of the instrument panel For details, refer to “Airflow selection”.
NOTE
When the dial is placed in the “”
or “” position, the air inlet
selection is automatically set to “outside air” mode.
See also:
Illuminated entry
The interior (dome) light and the map light
will illuminate when the “”
button is
pressed. These lights stay illuminated for
approximately 30 seconds if any of the
doors or the rear gate is ...
Seat heater (if equipped)
1) HIGH – Rapid heating
2) LOW – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side
The seat heater operates when the ignition switch is either in the “Acc” or “ON”
position.
T ...
Drive belts
It is unnecessary to check the deflection of the drive belt periodically because
your engine is equipped with an automatic belt tension adjuster. However, replacement
of the belt should be done ac ...