Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed.
2. When the HomeLink® indicator light begins to flash slowly (after approximately 20 seconds), position the hand-held transmitter of the device between 1 to 3 inches (25 to 76 mm) away from the HomeLink® button you wish to program.
3. Press and hold the hand-held transmitter button. The HomeLink® indicator light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
The programming for the previous device is now erased and the new device can be operated by pressing the HomeLink® button.
See also:
Synthetic leather upholstery
The synthetic leather material used on the
SUBARU may be cleaned using mild soap
or detergent and water, after first vacuuming
or brushing away loose dirt. Allow the
soap to soak in for a few ...
Tether anchorage location
Outback
Three tether anchorages, i.e., ones for the right, center and left positions,
are already installed on the rear edge of the roof. Open the cover flap to use each
anchorage. ...
System monitors
A diagnostic system continually monitors the readiness of the seatbelt pretensioner while the vehicle is being driven. The seatbelt pretensioners share the control module with the SRS airbag system.
...