Headlight flasher
To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.
When the headlights are on high beam, the high beam indicator light “” on the combination meter also illuminates.
Do not hold the lever in the flashing position for more than just a few seconds.
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system.
The light switch must always be turned to the “” position when it is dark outside.
The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions:
• The select lever is in a position other than the “P” position (AT models).
• The parking brake is fully released.
• The light switch is in the “OFF” or “” position.
NOTE
When the light switch is in the “ ” position, the front side marker lights, tail lights and license plate lights are illuminated.
See also:
Reclining the seatback
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
Also, do no ...
Seatbelt maintenance
To clean the seatbelts, use a mild soap
and lukewarm water. Never bleach or dye
the belts because this could seriously
affect their strength.
Inspect the seatbelts and attachments
including t ...
Seek tuning (SEEK)
Type A and B audio:
Type C audio:
Type D audio:
If you press the “” or “”
button briefly,
the radio will automatically search for a
receivable station and stop at the first one
it fin ...