Odometer/Trip meter
Turbo models
Non-turbo models
1) Trip knob
This meter displays the odometer and two trip meters when the ignition switch is in the “LOCK”, “Acc” or “ON” position.
If you press the trip knob when the ignition switch is in the “LOCK” position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.
The display can be switched as shown in the following illustration by pressing the trip knob.
*1: STI only
*2: or
, and
or
cannot be displayed when the ignition switch is in the “ON” position.
*3: Turbo models except STI
See also:
System monitors
SRS airbag system warning light
A diagnostic system continually monitors the readiness of the seatbelt pretensioner
while the vehicle is being driven. The seatbelt pretensioners share the control ...
Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the
doors lock and unlock. If desired, you may turn the audible signal off.
To deactivate the audible signal, perform the ...
Entering the vehicle following remote engine start
shutdown
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
transmitter within a few seconds immediately
following remote engine start shutdown. ...