Meter/Gauge needle illumination setting (turbo models except STI)
When the setting is activated or deactivated, the meter needles and gauge needles illuminate and turn off as follows.
Activated:
When the driver’s door is opened while the ignition switch is in the “LOCK” position, the needles illuminate and turn off after approximately 20 seconds. The illumination of the needles gradually turns off after the ignition switch is turned from the “ON” position to the “LOCK” position.
Deactivated:
The needles do not illuminate when the driver’s door is opened while the ignition switch is in the “LOCK” position. The illumination of the needles turns off immediately after the ignition switch is turned from the “ON” position to the “LOCK” position.
NOTE
• Even during the illumination after the driver’s door is opened, if the ignition switch is turned to the “ON” position, the combination meter will illuminate as usual.
• If the doors are locked by the remote keyless entry system during the illumination after the driver’s door is opened, the illumination will be turned off.
• Even while the illumination gradually turns off after the ignition switch is turned to the “LOCK” position, if the ignition switch is turned to the “ON” position, the combination meter illuminate as usual.
To change the setting:
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show or on the odometer and trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob.
*: or , and or cannot be displayed when the ignition switch is in the “ON” position.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the meter/gauge needles of your vehicle has been set for activation
at the time of shipment from the factory.
See also:
Unleaded gasoline
The neck of the fuel filler pipe is designed
to accept only an unleaded gasoline filler
nozzle. Under no circumstances should
leaded gasoline be used because it will
damage the emission contro ...
Instrument panel
1) Door locks
2) Outside mirror switch
3) Illumination brightness control
4) Headlight beam leveler
5) Light control switch
6) Combination meter
7) Wiper control lever
8) Hazard warning flash ...
Behavior with key lock-in prevention function operational
With the driver’s door open, the doors are
automatically kept unlocked even if the
front side of the power door locking switch
is pressed. ...