Anti-entrapment function (type A)
• Never attempt to test this function using fingers, hands or other parts of your body.
• The anti-entrapment function may not operate properly if some object gets trapped just before the window fully closes.
NOTE
• If a window detects an impact similar to that caused by trapping an object (for example, when the vehicle encounters a deep pothole), the anti-entrapment function may operate.
• The window cannot be operated for a few seconds after the anti-entrapment function operates.
• If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the antientrapment function is deactivated.
Initialize the power window to reactivate the anti-entrapment function. Refer to “Initialization of power window (type A)”.
While closing the driver’s window automatically, if the window senses a substantial enough object trapped between the window and the window frame, it automatically moves down slightly and stops.
See also:
4-door models
1. Remove the clip from the rear trunk trim with a screwdriver.
2. Open the rear portion of the side trunk trim panel.
1) Brake/tail and rear side marker light
2) Rear turn signal light
3) Bac ...
Type B audio set (if equipped)
The audio set will operate only when the ignition switch is in the “Acc” or “ON”
position.
● Power and sound controls: refer to page 5-6
● Radio operation: refer to page 5-9
● ...
Anchorage location
4-door models
1) For left seat
2) For center seat (for the Latin American models, a tether anchorage is not provided in this center location.)
3) For right seat
Two or three upper anchorages are i ...