Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to “Disarming the system”.
2. Sit in the driver’s seat and shut all doors (and the rear gate if your vehicle is a 5-door).
3. Turn the ignition switch to the “ON” position.
4. Hold down the REAR (UNLOCK) side of the driver’s power door locking switch, open the driver’s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
If the system was previously activated:
The odometer/trip meter screen displays “AL oF” and the horn sounds twice, indicating that the system is now deactivated.
If the system was previously deactivated:
The odometer/trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated.
NOTE
You may have the above setting change done by your SUBARU dealer.
See also:
CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted
with the label side down, the player displays “CHECK DISC”. Refer to “When the following
messages are ...
Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the pointer of the tachometer in the red zone.
In this range, fuel injection wi ...
Alarm system
It blinks to show the driver the operational status of the alarm system. For
detailed information, refer to “Alarm system” F2- 15. ...
