Behavior with key lock-in prevention function non-operational

• If the lock lever is turned to the rear (“LOCK”) position with the driver’s door open and the driver’s door is then closed with the lock lever in that position, the driver’s door is locked.

• If the spare key is used to lock the driver’s door from the outside of the vehicle, the door is locked.

This function’s operational/non-operational setting can be changed as follows.

• Models with genuine SUBARU navigation system:
The setting can be changed using the navigation monitor. For details, please refer to the Owner’s Manual supplement for the navigation system. Also, the setting can be changed by a SUBARU dealer.

Contact your SUBARU dealer for details.

• Models without genuine SUBARU navigation system:
The setting can be changed by a SUBARU dealer. Contact your SUBARU dealer for details.

NOTE
When leaving the vehicle, make sure you are holding the key before locking the doors.

    See also:

    Rear gate (5-door)
    The rear gate can be locked and unlocked using any of the following systems. • Power door locking switch: Refer to “Power door locking switches”. • Remote keyless entry system: Refer to “Remote ke ...

    Cooling and dehumidifying in high humidity and low temperature weather condition
    Under certain weather conditions (high relative humidity, low temperatures, etc.) a small amount of water vapor emission from the air outlets may be noticed. This condition is normal and does not ...

    Front seats
    WARNING ● Never adjust the seat while driving to avoid the possibility of loss of vehicle control and of personal injury. ● Before adjusting the seat, make sure the hands and feet of r ...