Rear combination lights
1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly.
2. Slide the rear combination light assembly rearward and remove it from the vehicle.
1) Brake/tail light
2) Rear turn signal light
3) Back-up light
3. Remove the bulb socket from the rear combination light assembly by turning it counterclockwise.
4. Pull the bulb out of the bulb socket and replace it with a new one.
5. Set the bulb socket into the rear combination light assembly and turn it clockwise until it locks.
6. Put the rear combination light assembly into place while aligning the clip with the guide on the vehicle.
7. Tighten the upper and lower screws.
See also:
Installing a rearward facing child restraint
1. Place the child restraint system in the rear seating position.
2. Run the lap and shoulder belt through or around the child restraint system
following the instructions provided by its manufact ...
Selecting category (only when connecting iPod®)
When the “LIST” button is pressed for less than 1.5 seconds, the iPod® menu is displayed.
Each time you turn the “TUNE/TRACK/ CH” dial clockwise, the displayed category changes in the following seq ...
Overhead console
To open the console, push on the lid lightly and it will automatically open.
CAUTION
When your vehicle is parked in the sun or on a warm day, the inside of the overhead
console heats up. Avoid s ...