Battery

- Before beginning work on or near

- Before beginning work on or near any battery, be sure to extinguish all cigarettes, matches, and lighters.

Never expose a battery to an open flame or electric sparks.

Batteries give off a gas which is highly flammable and explosive.

- For safety, in case an explosion does occur, wear eye protection or shield your eyes when working near any battery. Never lean over a battery.

- Do not let battery fluid contact eyes, skin, fabrics, or paint because battery fluid is a corrosive acid. If battery fluid gets on your skin or in your eyes, immediately flush the area with water thoroughly.

Seek medical help immediately if acid has entered the eyes.

If battery fluid is accidentally swallowed, immediately drink a large amount of milk or water, and seek medical attention immediately.

- To lessen the risk of sparks, remove rings, metal watchbands, and other metal jewelry. Never allow metal tools to contact the positive battery terminal and anything connected to it WHILE you are at the same time in contact with any other metallic portion of the vehicle because a short circuit will result.

- Keep everyone including children away from the battery.

- Charge the battery in a wellventilated area.

- Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Batteries also contain other chemicals known to the State of California to cause cancer.

Wash hands after handling.

1) Cap

1) Cap
2) Upper level
3) Lower level

It is unnecessary to periodically check the battery fluid level or periodically refill with distilled water.

However, if the battery fluid level is below the lower level, remove the cap. Fill to the upper level with distilled water.

Never use more than 10 amperes

Never use more than 10 amperes when charging the battery because it will shorten battery life.

    See also:

    2010 Subaru Outback review
    A few things have changed with the 2010 Subaru Outback. It's undergone a redesign that's full of positive changes, but there's one change I'm not crazy about - the exterior. It looks like it's bee ...

    Windshield wiper blade assembly
    1. Raise the wiper arm off the windshield. 1) Open the cover 2) Pull down the wiper blade 2. Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in t ...

    Vehicle load limit – how to determine
    The load capacity of your vehicle is determined by weight, not by available cargo space. The load limit of your vehicle is shown on the vehicle placard attached to the driver’s side B-pillar. Loca ...