Rear window wiper blade rubber

1. Pull out the end of the blade rubber

1. Pull out the end of the blade rubber assembly to unlock it from the plastic support.

2. Pull the blade rubber assembly out of

2. Pull the blade rubber assembly out of the plastic support.

1) Metal spines

1) Metal spines

3. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and install them in the new blade rubber.

4. Align the claws of the plastic support

4. Align the claws of the plastic support with the grooves in the blade rubber assembly, then slide the blade rubber assembly into place.

Securely retain both ends of the rubber

Securely retain both ends of the rubber with the stoppers on the plastic support ends. If the rubber is not retained properly, the wiper may scratch the rear window glass.

    See also:

    Selecting phone
    To select the registered cell phone for connecting to the in-vehicle equipment, perform the following procedure. 1. Select the “SELECT PHONE” menu. If no cell phones are registered, “EMPTY” is ...

    Operation
    The SRS side airbag and SRS curtain airbag can function only when the ignition switch is in the “ON” position. The driver’s and front passenger’s SRS side airbags and SRS curtain airbags deploy ind ...

    Passenger compartment area
    1) Lower anchorages for child restraint system (page 1-33) 2) Seatbelt (page 1-12) 3) Center console (page 6-6) 4) Front seat (page 1-2) 5) Rear seat (page 1-7) 1) Top tether anchorages (page ...