Rear window wiper blade assembly

1. Raise the wiper arm off the rear window.

2. Turn the wiper blade assembly counterclockwise.

2. Turn the wiper blade assembly counterclockwise.

3. Pull the wiper blade assembly toward

3. Pull the wiper blade assembly toward you to remove it from the wiper arm.

4. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.

5. Hold the wiper arm by hand and slowly lower it in position.

    See also:

    Tire pressure monitoring system (TPMS) (if equipped)
    The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pre ...

    Vehicle Dynamics Control warning light/ Vehicle Dynamics Control operation indicator light
    ...

    Tone and balance control
    Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the following sequence. Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The control func ...