To engage the service mode

Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “button on the remote control transmitter” button on the remote control transmitter three times. The system will pause for 1 second and then flash the turn signal lights and honk the horn three times indicating that the system is in service mode. When attempting to activate the remote start system while in service mode, the turn signal lights will flash and the horn will honk two times and will not start.

    See also:

    Power seat (if equipped)
    WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place ...

    Temporary spare tire
    WARNING ● Never tow a trailer when the temporary spare tire is used. The temporary spare tire is not designed to sustain the towing load. Use of the temporary spare tire when towing can res ...

    Rear window side seating position
    1) Head restraint 2) Release button To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: Whil ...