When “CHECK DEVICE” is displayed
This message is displayed under the following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-corresponding iPod® is
connected
- When a connected iPod® is frozen
- When a transmission malfunction occurs
- When an iPod® confirmation malfunction
occurs
- When a HUB class USB storage
device is connected
Disconnect the USB storage device/iPod®
and check it.
See also:
Initializing the registered data
To initialize the registered data, perform the following procedure.
1. Select the “SETUP” menu.
2. Select the “SYSTEM SETUP” menu.
3. Select “INITIALIZE” by operating the “TUNE/TRACK/CH” dial.
4. ...
Tire pressures and wear
Maintaining the correct tire pressures helps to maximize the tires’ service lives and is essential for good running performance.
Check and, if necessary, adjust the pressure of each tire (including t ...
Deleting the redial data
1. Select the “REDIAL” menu.
2. Select the phone number by operating the “TUNE/TRACK/CH” dial.
3. Select the “DELETE” menu.
4. Select the “CONFIRM” menu. Then “DELETED” is displayed and the selecte ...