Connecting USB storage device / iPod®

Do not operate an iPod® while

Do not operate an iPod® while driving; it may distract your attention from driving and can lead to an accident.

- If the data stored in an iPod® is

- If the data stored in an iPod® is deleted while it is connected to the in-vehicle system, the data cannot be recovered.

- Do not store an iPod® in the vehicle. If an iPod® is left in the vehicle for a long period of time, it may be deformed, discolored or damaged by high temperature.

NOTE
- Even if a USB storage device or iPod® is connected, it cannot be played unless the pressed. button is pressed.

- A movie cannot be played while an iPod® is connected.

- While an iPod® is connected, the iPod® cannot be operated using the click wheel on the iPod® (except some models).

- When using an iPod® by connecting it to in-vehicle equipment, the order of the list items displayed on the invehicle equipment may be different from that on the iPod®. However, this does not indicate a malfunction.

- An iPod® battery that is connected to in-vehicle equipment will be charged when the ignition switch is in the “ON” or “Acc” position. However, activation of the iPod® may be delayed if the battery charge of the iPod® is low.

- If an iPod® does not activate after operation, disconnect the connection cable from the iPod® and reset it. For the resetting procedure, see the User’s Guide that comes with the iPod®.

- If an iPod® and the connection cable are connected improperly, the iPod® cannot be powered on or will not be recognized by in-vehicle equipment. In this case, disconnect the connection cable from the iPod®, and then connect it again.

The USB connector is located in the

The USB connector is located in the center console. Use the connector to connect a USB storage device/iPod®.

    See also:

    Door interlock switch
    1) Door interlock switch Although the map light switches are in the OFF position (manually off), the map lights can be set to illuminate automatically in conjunction with a door opening, etc. b ...

    Compass calibration
    1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. You can also ca ...

    Before starting out on a trip
    - Check that the vehicle and vehicle-tohitch mounting are in good condition. If any problems are apparent, do not tow the trailer. - Check that the vehicle sits horizontally with the trailer ...