Meter needles/gauge illumination setting (models with type A combination meter)
When the setting is activated or deactivated, the meter needles and gauge illuminate and turn off as follows.
Activated:
When the driver’s door is opened while the ignition switch is in the “LOCK” position, the needles and gauge illuminate and turn off after approximately 20 seconds.
The illumination gradually turns off after the ignition switch is turned from the “ON” position to the “LOCK” position.
Deactivated:
The needles and gauge do not illuminate when the driver’s door is opened while the ignition switch is in the “LOCK” position.
The illumination turns off immediately after the ignition switch is turned from the “ON” position to the “LOCK” position.
NOTE
- Even during the illumination after
the driver’s door is opened, if the
ignition switch is turned to the “ON”
position, the combination meter will
illuminate as usual.
- If the doors are locked by the remote keyless entry system during the illumination after the driver’s door is opened, the illumination will be turned off.
- Even while the illumination gradually turns off after the ignition switch is turned to the “LOCK” position, if the ignition switch is turned to the “ON” position, the combination meter illuminates as usual.
To change the setting:
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show or on the trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob.
*: or , and or cannot be displayed when the ignition switch is in the “ON” position.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter needles/gauge of your vehicle
has been set for activation
at the
time of shipment from the factory.
See also:
Power seat (if equipped)
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
Also, do not place ...
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the “”
button three times in a 5- ...
Air conditioner compressor shut-off when engine is heavily loaded
To improve acceleration and gas mileage,
the air conditioner compressor is designed
to temporarily shut off during air conditioner
operation whenever the accelerator
is fully depressed such as ...