Canceling the function for meter/gauge needle movement upon turning on the ignition switch
Type A
Type B
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show or on the odometer/trip meter display.
The display can be switched as shown in the following illustration by pressing the trip knob.
Type A:
*: or , and or cannot be displayed when the ignition switch in the “ON” position.
Type B:
*: or cannot be displayed when the ignition switch is in the “ON” position.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
- Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation
at the time of shipment from the
factory.
- It is not possible to cancel the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Cancel the setting when the ignition switch is in the “LOCK” or “Acc” position.
See also:
Fastening the seatbelt
WARNING
● Never use a belt that is twisted or reversed. In an accident, this can increase
the risk or severity of injury.
● Keep the lap belt as low as possible on your hips. In a coll ...
Illuminated entry
The interior (dome) light and the map light
will illuminate when the “”
button is
pressed. These lights stay illuminated for
approximately 30 seconds if any of the
doors or the rear gate is ...
Audio control buttons (if equipped)
Type A audio
Type B audio
These buttons are located on the spokes of the steering wheel. They allow the
driver to control audio functions without taking his/her hands off the steering
wheel. ...