Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered.
Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle.
When the ignition switch is turned to the “ON” position, the indicator light will light for 1 second and then flash as follows.
- When a door or rear gate was opened:
5 times
- When the ignition switch was turned to
the “ON” position: 3 times
- When a strong impact or multiple
impacts were sensed: twice (only vehicles
with shock sensors (dealer option))
- When a light impact was sensed: once
(only vehicles with shock sensors (dealer
option))
NOTE
Any of the above indicator light flashings
will recur each time the ignition
switch is turned to the “ON” position.
Rearming the alarm system cancels the flashing.
See also:
Parking brake
To set the parking brake, depress the brake pedal firmly and hold it down until the parking brake lever is fully pulled up.
To release the parking brake, pull the lever up slightly, press the relea ...
Warning and indicator lights
Several of the warning and indicator lights illuminate momentarily and then turn off when the ignition switch is initially turned to the “ON” position. This permits checking the operation of the bulbs ...
Removing the wheel cover
Removing the wheel cover
1) Notch
2) Valve hole
Insert a wheel cover remover into the
notch part on the opposite side of the
valve hole and pry the wheel cover to
remove it. ...