Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to “Disarming the system”.
2. Sit in the driver’s seat and shut all doors and the rear gate.
3. Turn the ignition switch to the “ON” position.
4. Hold down the UNLOCK side of the driver’s power door locking switch, open the driver’s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
If the system was previously activated:
The odometer/trip meter screen displays “AL oF” and the horn sounds twice, indicating that the system is now deactivated.
If the system was previously deactivated:
The odometer/trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
See also:
To deactivate
1. Stop your vehicle in a flat and safe place and apply the parking brake.
2. Turn off the engine.
3. Restart the engine.
4. Confirm the following items.
• The ABS warning light turns off.
• Th ...
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
Turn the ignition switch to th ...
Display selection (type A, B and C audio)
Press the “TEXT” button while receiving
the satellite radio to change the display as
follows.
...